Crystal lamp installation method

1. Check the accessories

Before installation, check whether the European-style crystal lamp accessories are complete. The accessories mainly include ceiling plate, hanging plate and back strip. The ceiling plate is directly in contact with the wall and connects the bridge between the wall and the lamps; the hanging plate is installed on the ceiling plate, which is the bridge connecting the wall and the ceiling plate, so the lamps and lanterns can not be missing.

2. Install the hanging board

The current roof is made of brick or cement, so when installing the hanging board, it is necessary to pre-embed hooks, screws and bolts to fix it. It is necessary to choose a fixed nut that matches the bearing capacity and the weight of the crystal lamp, and then use the screws in the lamp to fix it. The hanging plate is fixed on the expansion screw, pay attention to keep the balance of the hanging plate, and do not tighten one side first.

521b 5

3. Install the bulb

When installing the bulb, pay attention to the wiring. The wiring should be connected to the center contact terminal, and the neutral wire should be connected to the screw terminal. If the lamp uses a screw cap, the wire should be connected to the top core of the lamp cap, and the neutral wire should be connected to the screw. After the light bulb is installed, you need to turn on the switch to check whether the light bulb is on. If the light bulb is not on, check it in time.

4. Install accessories

Be very careful when installing accessories, because accessories are fragile, you must be very careful when installing them.

521b 7

5. Installation effect inspection

After the installation of the entire European-style crystal lamp is completed, check whether the lamp can operate normally. If there is a problem, check whether the circuit or the remote control is faulty. If it still cannot be solved, contact the manufacturer to check and solve the problem in time.